Description:
Built on the foundation of the Com-Tech series, Crown's CTs Series offers new flexibility and value for installed sound applications. The Com-Tech Series were the first to offer independent selection of high- and low-impedance operation for a specific channel, and CTs Series amplifiers continue that tradition, with power levels and features carefully chosen to perfectly integrate into fixed install design requirements.
Features:
|
Frequency Response (at 1 watt, 20Hz - 20 kHz) ±0.25
dB
Phase Response (at 1 watt, 10Hz - 20 kHz) ±20°
Signal to Noise Ratio below rated power (20 Hz to 20
kHz) <-105 dB A-weighted
Total Harmonic Distortion (THD) at 1 watt, from 20 Hz
to 20 kHz <0.05%
Damping Factor 10 Hz to 400 Hz >500
Crosstalk (below rated power, 20 Hz to 1 kHz) >80 dB
Common Mode Rejection (CMR) (20 Hz to 1 kHz) >50 dB
DC Output Offset (Shorted input) <10 mV
Input Impedance nominally balanced, nominally
unbalanced 20 k ohms, 10 k ohms
Maximum Input Level (before input compression) +20
dBu Load Impedance (Note: Safe with all types of loads):
Stereo 2, 4, 8 and 8 ohms (70V)
Bridge Mono 4, 8, 16 and 16 ohms (140V) Voltage Gain
(at maximum level setting), 1.4V sensitivity:
4/8 Ohm Operation 36:1 (31 dB)
70V Operation 39:1 (32 dB)
100V Operation
Required AC Mains 120V 60 Hz, 220/230/240V/50 Hz
Power Draw at Idle (120VAC mains):
All channels in 4/8 ohm mode 24W (Standby Mode)
All channels in 70V mode 24W (Standby Mode)
Cooling Variable-speed forced air Dimensions:
Width, 19 in. (48.3 cm.)
Height, 3.5 in. (8.9 cm.)
Depth 14 in. (35.6 cm.)
Net Weight 24 lb (10.9 kg)
|
|
